Connecting your phone to your NOX-160 is very simple. There are two ways to do this: wired or via Bluetooth.
Wired connection
After turning on your speaker, ensure that the blue LED next to the Input button is off. If it's not, press and hold the button for three seconds. Once the light is off, lower the volume and connect your device using a Jack cable. You can now set the volume to your desired level and enjoy NOX's exceptional battery life.
It's also possible to connect your phone to two interconnected NOX speakers, in two ways, depending on what you want.
For stereo sound, a 3.5mm Jack to dual 6.3mm Jack splitter is provided with your NOX. This will allow you to use the previous method but by plugging your two Jack cables into the IN of both speakers for better spatialized sound.
For mono sound across the entire chain, connect the first speaker with a 6.3 mm Jack to the IN button on your phone and connect the two speakers with another 6.3 mm Jack cable by plugging the first speaker into the OUT button and the second into the IN button! This method allows you to connect all NOX speakers to each other.
Bluetooth connection
As you probably suspect, you'll also need to turn on the speaker. This time, check that the blue LED is blinking; otherwise, press the Input button for 3 seconds. Once done, go to the Bluetooth section of your phone and connect to the Nox, displayed as Nox-XXXX. Enter the code, 1234, then wait for the LED to stop blinking. That's it, your phone is paired!
A small clarification: the modes are saved each time you turn off the speaker. There's no need to check the blue LED if you consistently use it in wired or Bluetooth mode.
